enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The term fine adjustment screw typically refers to screws with threads from 40–100 TPI (Threads Per Inch) (0.5 mm to 0.2 mm pitch) and ultra fine adjustment screw has been used to refer to 100–254 TPI (0.2 mm to 0.1 mm pitch). These screws are most frequently used in applications where the screw is used to control fine motion of an object.

3. Confirmat screw - Wikipedia

   en.wikipedia.org/wiki/Confirmat_screw

   Confirmat screws on a sheet of the particleboard material in which they were designed to hold. Diagram of a hex-headed confirmat screw, made to be turned with an allen key A confirmat screw holding a butt joint in melamine-coated particleboard. A specialized stepped drill bit and a screw to match it. The screw is covered with a cosmetic plastic ...

4. Cement board - Wikipedia

   en.wikipedia.org/wiki/Cement_board

   A cement board is a combination of cement and reinforcing fibers formed into sheets, of varying thickness that are typically used as a tile backing board. [1] Cement board can be nailed or screwed to wood or steel studs to create a substrate for vertical tile and attached horizontally to plywood for tile floors, kitchen counters and backsplashes.

5. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   ISO general-purpose screw threads—Basic profile—Part 2: Inch screw threads: V Thread Form ISO 261:1998: ISO general purpose metric screw threads—General plan: V Thread Form: M6x1 ISO 262:1998: ISO general purpose metric screw threads—Selected sizes for screws, bolts and nuts: V Thread Form ISO 724:1993

6. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Self-tapping screws can be divided into two classes: [3] those that displace material (especially plastic and thin metal sheets) without removing it, known as "thread-forming" self-tapping screws, and self-tappers with sharp cutting surfaces that remove the material as they are inserted, termed "thread-cutting" self-tapping screws.

7. British Association screw threads - Wikipedia

   en.wikipedia.org/wiki/British_Association_screw...

   BS 93:1951 — Specification for British Association (B.A.) screw threads with tolerances for sizes 0 B.A. to 16 B.A. BS 93:2008 — British Association (B.A.) screw threads — Requirements The angle of the thread is 47.5° [ 4 ] : 2 and the depth of thread is 0.6 times the pitch with rounded tops and bottoms.