enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wire wrap - Wikipedia

   en.wikipedia.org/wiki/Wire_wrap

   Mechanical wire wrap tool Electrical wire wrap tool; pneumatic (air-powered) tools are also available. A "wire wrap tool" has two holes. The wire and 1 ⁄ 4 in (6.4 mm) of insulated wire are placed in a hole near the edge of the tool. The hole in the center of the tool is placed over the post. The tool is rapidly twisted.

3. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

4. Home Depot - Wikipedia

   en.wikipedia.org/wiki/Home_Depot

   This is an accepted version of this page This is the latest accepted revision, reviewed on 6 December 2024. American multinational home improvement supplies retailing company The Home Depot, Inc. An aerial view of a Home Depot in Onalaska, Wisconsin Company type Public Traded as NYSE: HD DJIA component S&P 100 component S&P 500 component Industry Retail (home improvement) Founded February 6 ...

5. Cable tie - Wikipedia

   en.wikipedia.org/wiki/Cable_tie

   A cable tie (also known as a hose tie, tie wrap, wire tie, zap-straps, or zip tie) is a type of fastener for holding items together, primarily electrical cables and wires. Because of their low cost, ease of use, and binding strength, cable ties are ubiquitous, finding use in a wide range of other applications.

6. Coil binding - Wikipedia

   en.wikipedia.org/wiki/Coil_binding

   One of the strengths of spiral coil binding is that the supplies are available in a variety of lengths. [citation needed] Most users purchase spiral coils in twelve inch lengths. [citation needed] This spine is inserted onto an eleven-inch document and the excess length of coil is cut and crimped at each end of the book. However, the forming ...

7. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   Wire wrap connections are made by wrapping solid wire around a square post with a wire wrap tool. This type of connection is often used in developing prototypes. The wire wrap and IDC connections styles had to contend with incompatible pin spacing to the 0.05 in ribbon cable or 0.1 in proto board grid, especially for larger pin counts.

8. 'I heard it and felt it': Chemical facility explosion leaves ...

   www.aol.com/shelter-place-ordered-building...

   An explosion at a chemical facility in Louisville, Kentucky Tuesday afternoon left at least 11 people hospitalized, officials confirmed.. The blast occurred around 3 p.m. local time at the ...

9. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.