Search results
Results from the WOW.Com Content Network
An oxygen sensor (or lambda sensor, where lambda refers to air–fuel equivalence ratio, usually denoted by λ) or probe or sond, is an electronic device that measures the proportion of oxygen (O 2) in the gas or liquid being analyzed. [1] It was developed by Robert Bosch GmbH during the late 1960s under the supervision of Günter Bauman. [1]
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
A sudden fail-open fault can cause multiple secondary failures if it is fast and the circuit contains an inductance; this causes large voltage spikes, which may exceed 500 volts. A broken metallisation on a chip may thus cause secondary overvoltage damage. [1]
In an electric power system, a fault or fault current is any abnormal electric current. For example, a short circuit is a fault in which a live wire touches a neutral or ground wire. An open-circuit fault occurs if a circuit is interrupted by a failure of a current-carrying wire (phase or neutral) or a blown fuse or circuit breaker.
The coefficient is defined as Lambda coefficient. If Lambda > 1 = lean mixture, excess of air. If Lambda < 1 = rich mixture, excess of gasoline. A lean mixture contains an excess of oxygen. The surplus oxygen will react with nitrogen to (oxides of nitrogen), if the temperature is high enough (around 1600 °C) for enough time to permit so.
Automatic control of a process. autorecloser A circuit protection device for overhead power distribution lines which briefly interrupts a circuit when a fault is detected, then restores the circuit in the expectation the fault has cleared. autotransformer A transformer where the primary and secondary circuits share some of the transformer windings.
The voltage v and current i variables in an electrical component must be defined according to the passive sign convention; positive conventional current is defined to enter the positive voltage terminal; this means power P flowing from the circuit into the component is defined to be positive, while power flowing from the component into the circuit is negative.
A time-domain reflectometer; an instrument used to locate the position of faults on lines from the time taken for a reflected wave to return from the discontinuity.. A signal travelling along an electrical transmission line will be partly, or wholly, reflected back in the opposite direction when the travelling signal encounters a discontinuity in the characteristic impedance of the line, or if ...