Search results
Results from the WOW.Com Content Network
Rebar (short for reinforcement bar or reinforcing bar), known when massed as reinforcing steel or steel reinforcement, [1] is a tension device added to concrete to form reinforced concrete and reinforced masonry structures to strengthen and aid the concrete under tension.
ACI Code 7.10.4.2: For cast-in-place construction, size of spirals shall not be less than 3/8 in. diameter. ACI Code 7.10.4.3: Clear spacing between spirals shall not exceed 3 in., nor be less than 1in. Section 10.9.3 adds an additional lower limit to the amount of spiral reinforcement via the volumetric spiral reinforcement ratio ρ s.
A Johnson bar (also Johnson corrugated bar) is a type of corrugated high-carbon steel [1] rebar used to reinforce concrete. The Johnson bar was invented by A.L. Johnson [ 2 ] of the St. Louis Expanded Metal Company.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Characteristics – Generally consisting of portland cement, water, construction aggregate (coarse and fine), and steel reinforcing bars , concrete is cheaper in comparison to structural steel. Strength – Concrete is a composite material with relatively high compressive strength properties, but lacking in tensile strength/ductility.
Reinforced concrete, also called ferroconcrete, is a composite material in which concrete's relatively low tensile strength and ductility are compensated for by the inclusion of reinforcement having higher tensile strength or ductility.
Logo of Eurocode 2 An example of a concrete structure. In the Eurocode series of European standards (EN) related to construction, Eurocode 2: Design of concrete structures (abbreviated EN 1992 or, informally, EC 2) specifies technical rules for the design of concrete, reinforced concrete and prestressed concrete structures, using the limit state design philosophy.
Reinforcement bars are pre-installed, just like in the case of conventionally cast concrete, and the rheology of the concrete is adapted to retain the shape of the slipforming formwork before concrete hydrates enough to sustain self-weight. [14] Concrete facade mullions of varying cross-sections are produced for a DFAB house [15] in Switzerland.