Search results
Results from the WOW.Com Content Network
The surface energy of a liquid may be measured by stretching a liquid membrane (which increases the surface area and hence the surface energy). In that case, in order to increase the surface area of a mass of liquid by an amount, δA, a quantity of work, γ δA, is needed (where γ is the surface energy density of the liquid).
These electric charges are constrained on this 2-D surface, and surface charge density, measured in coulombs per square meter (C•m −2), is used to describe the charge distribution on the surface. The electric potential is continuous across a surface charge and the electric field is discontinuous, but not infinite; this is unless the surface ...
Metallic hydrogen (recombination energy) 216 [2] Specific orbital energy of Low Earth orbit (approximate) 33.0: Beryllium + Oxygen: 23.9 [3] Lithium + Fluorine: 23.75 [citation needed] Octaazacubane potential explosive: 22.9 [4] Hydrogen + Oxygen: 13.4 [5] Gasoline + Oxygen –> Derived from Gasoline: 13.3 [citation needed] Dinitroacetylene ...
Therm (thm) – unit of heat energy. In the US gas industry it is defined as exactly 100,000 BTU 59 °F. It is approximately the heat equivalent of burning 100 cubic feet (2.8 m 3) of natural gas (~105.5 MJ). Quad – unit of energy equal to 10 15 (a short-scale quadrillion) BTU.
Quantity (common name/s) (Common) symbol/s Defining equation SI unit Dimension Temperature gradient: No standard symbol K⋅m −1: ΘL −1: Thermal conduction rate, thermal current, thermal/heat flux, thermal power transfer
For example, from Fe 2+ + 2 e − ⇌ Fe(s) (–0.44 V), the energy to form one neutral atom of Fe(s) from one Fe 2+ ion and two electrons is 2 × 0.44 eV = 0.88 eV, or 84 907 J/(mol e −). That value is also the standard formation energy (∆ G f °) for an Fe 2+ ion, since e − and Fe( s ) both have zero formation energy.
The SET rate follows the inverse of the fourth power of the distance [2] = where is the donor emission lifetime; is the distance between donor-acceptor; is the distance at which SET efficiency decreases to 50% (i.e., equal probability of energy transfer and spontaneous emission).
The higher the energy density of the fuel, the more energy may be stored or transported for the same amount of volume. The energy of a fuel per unit mass is called its specific energy. The adjacent figure shows the gravimetric and volumetric energy density of some fuels and storage technologies (modified from the Gasoline article).