enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Nitric acid - Wikipedia

    en.wikipedia.org/wiki/Nitric_acid

    Nitric acid is normally considered to be a strong acid at ambient temperatures. There is some disagreement over the value of the acid dissociation constant, though the pK a value is usually reported as less than −1. This means that the nitric acid in diluted solution is fully dissociated except in extremely acidic solutions.

  3. Leveling effect - Wikipedia

    en.wikipedia.org/wiki/Leveling_effect

    The strength of a strong acid is limited ("leveled") by the basicity of the solvent. Similarly the strength of a strong base is leveled by the acidity of the solvent. When a strong acid is dissolved in water, it reacts with it to form hydronium ion (H 3 O +). [2] An example of this would be the following reaction, where "HA" is the strong acid:

  4. Acid dissociation constant - Wikipedia

    en.wikipedia.org/wiki/Acid_dissociation_constant

    A buffer solution of a desired pH can be prepared as a mixture of a weak acid and its conjugate base. In practice, the mixture can be created by dissolving the acid in water, and adding the requisite amount of strong acid or base. When the pK a and analytical concentration of the acid are known, the extent of dissociation and pH of a solution ...

  5. Acid strength - Wikipedia

    en.wikipedia.org/wiki/Acid_strength

    For example, acetic acid is a weak acid which has a = 1.75 x 10 −5. Its conjugate base is the acetate ion with K b = 10 −14 /K a = 5.7 x 10 −10 (from the relationship K a × K b = 10 −14), which certainly does not correspond to a strong base. The conjugate of a weak acid is often a weak base and vice versa.

  6. Neutralization (chemistry) - Wikipedia

    en.wikipedia.org/wiki/Neutralization_(chemistry)

    Acetic acid is an example of a weak acid. The pH of the neutralized solution resulting from HA + OH − → H 2 O + A −. is not close to 7, as with a strong acid, but depends on the acid dissociation constant, K a, of the acid. The pH at the end-point or equivalence point in a titration may be calculated as follows.

  7. Mineral acid - Wikipedia

    en.wikipedia.org/wiki/Mineral_acid

    Commonly used mineral acids are sulfuric acid (H 2 SO 4), hydrochloric acid (HCl) and nitric acid (HNO 3); these are also known as bench acids. [1] Mineral acids range from superacids (such as perchloric acid) to very weak ones (such as boric acid). Mineral acids tend to be very soluble in water and insoluble in organic solvents.

  8. Nitrous acid - Wikipedia

    en.wikipedia.org/wiki/Nitrous_acid

    Nitrous acid (molecular formula H N O 2) is a weak and monoprotic acid known only in solution, in the gas phase, and in the form of nitrite (NO − 2) salts. [3] It was discovered by Carl Wilhelm Scheele, who called it "phlogisticated acid of niter". Nitrous acid is used to make diazonium salts from amines.

  9. Buffer solution - Wikipedia

    en.wikipedia.org/wiki/Buffer_solution

    A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...