Search results
Results from the WOW.Com Content Network
The slipped form of the buntline hitch (on the right) can easily be untied by pulling the hanging end and withdrawing the loop. A slipped knot is any knot that unties when an end is pulled. Thus, tying the slipped form of a knot makes it easier to untie, especially when the knot is prone to jamming. [1] A slip knot is just one variety of ...
The end of a wire rope tends to fray readily, and cannot be easily connected to plant and equipment. There are different ways of securing the ends of wire ropes to prevent fraying. The common and useful type of end fitting for a wire rope is to turn the end back to form a loop. The loose end is then fixed back on the wire rope.
Finally the loose end of the wound whipping is passed through the loop so that both ends may be drawn securely inside the winding. [ 2 ] Whippings may also be applied by hand or using a palm and needle, and either simply tied off or made neat and permanent by reeving the twine's cut ends into or behind the whipping, sewing them to adjacent ...
release (practice) – The act of relaxing the fingers of the drawing hand (see Bow draw) to free an arrow from a bow (a.k.a. loose) release aid (equipment) — A small handheld object that can be clipped to a bowstring and releases when a trigger is pressed, or upon a certain physical action. Often called simply a "release".
This double-wrap holds the shoelaces more securely tied while still allowing them to be untied with a (slightly firmer) pull on the loose end(s). Possibly the simplest, also neat and quite effective, is after tying a common bow to tie a half-hitch with one or other loose end around its adjacent half bow, close to the knot; it is untied by ...
reaches from the foremast-head towards the bowsprit end mainstay extends to the ship's stem. The mizzenstay stretches to a collar on the main-mast, immediately above the quarterdeck. fore-topmast stay goes to the end of the bowsprit, a little beyond the forestay, on which the fore-topmast staysail runs on hanks. main-topmast stay
A noose is a loop at the end of a rope in which the knot tightens under load and can be loosened without untying the knot. The knot can be used to secure a rope to a post, pole, or animal but only where the end is in a position that the loop can be passed over.
The terminator is usually placed at the end of a transmission line or daisy chain bus (such as in SCSI), and is designed to match the AC impedance of the cable and hence minimize signal reflections, and power losses. Less commonly, a terminator is also placed at the driving end of the wire or cable, if not already part of the signal-generating ...