Search results
Results from the WOW.Com Content Network
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
A binary trigger is a trigger for a semiautomatic firearm that drops the hammer both when the trigger is pulled, and also when it is released. Examples include the AR-15 series of rifles, produced by Franklin Armory, Fostech Outdoors, and Liberty Gun Works. The AR-15 trigger as produced by Liberty Gun Works only functions in pull and release ...
This allows for an increased rate of fire. However, the shooter must still manually pull the trigger each time it resets for any subsequent shot to be fired. An image of a forced reset trigger from ATF’s Ammunition Technology Division: Technical Bulletin 22-01. Forced reset triggers are installed through replacement of the trigger control group.
A binary trigger is a modification that allows a weapon to fire one round when the trigger is pulled and another when it is released — in essence doubling the firing capacity, firearms experts ...
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.
A Glock switch functions by applying force to a semi-automatic pistol's trigger bar to prevent it from limiting fire to one round of ammunition per trigger pull. [5] [6] Normally, in a semiautomatic pistol, after firing, the trigger bar catches the firing pin until the trigger is released, but when depressed by the switch it does not catch.
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A Slide Fire Solutions bump fire stock on a WASR-10 semiautomatic rifle WASR-10 rifle without a bump stock fitted. Bump stocks or bump fire stocks are gun stocks that can be used to assist in bump firing, the act of using the recoil of a semi-automatic firearm to fire cartridges in rapid succession.