Search results
Results from the WOW.Com Content Network
The DC load line is the load line of the DC equivalent circuit, defined by reducing the reactive components to zero (replacing capacitors by open circuits and inductors by short circuits). It is used to determine the correct DC operating point, often called the Q point. Once a DC operating point is defined by the DC load line, an AC load line ...
Three-phase transformer with four-wire output for 208Y/120 volt service: one wire for neutral, others for A, B and C phases. Three-phase electric power (abbreviated 3ϕ[ 1 ]) is a common type of alternating current (AC) used in electricity generation, transmission, and distribution. [ 2 ] It is a type of polyphase system employing three wires ...
An electrical load is an electrical component or portion of a circuit that consumes (active) electric power, [1][2] such as electrical appliances and lights inside the home. The term may also refer to the power consumed by a circuit. This is opposed to a power supply source, such as a battery or generator, which provides power.
Transmission line. Schematic of a wave moving rightward down a lossless two-wire transmission line. Black dots represent electrons, and the arrows show the electric field. One of the most common types of transmission line, coaxial cable. In electrical engineering, a transmission line is a specialized cable or other structure designed to conduct ...
In power engineering, a single-line diagram (SLD), also sometimes called one-line diagram, is a simplest symbolic representation of an electric power system. [1][2] A single line in the diagram typically corresponds to more than one physical conductor: in a direct current system the line includes the supply and return paths, in a three-phase ...
Hot is any line or neutral conductor (wire or otherwise) connected with an electrical system that has electric potential relative to electrical ground or line to neutral. Ground is a safety conductor with a low impedance path to earth. It is often called the "ground wire," or safety ground. It is either bare or has green insulation. [1]
Two additional circuits are obscured by trees on the far right. The entire 6809 MW [ 1 ] nameplate generation capacity of the dam is accommodated by these six circuits. Electric power transmission is the bulk movement of electrical energy from a generating site, such as a power plant, to an electrical substation.
In power engineering, the power-flow study, or load-flow study, is a numerical analysis of the flow of electric power in an interconnected system. A power-flow study usually uses simplified notations such as a one-line diagram and per-unit system, and focuses on various aspects of AC power parameters, such as voltages, voltage angles, real power and reactive power.