Search results
Results from the WOW.Com Content Network
Overview. PCI devices have a set of registers referred to as configuration space and PCI Express introduces extended configuration space for devices. Configuration space registers are mapped to memory locations. Device drivers and diagnostic software must have access to the configuration space, and operating systems typically use APIs to allow ...
Burst reads (using linear incrementing) are permitted in PCI configuration space. Unlike I/O space, standard PCI configuration registers are defined so that reads never disturb the state of the device. It is possible for a device to have configuration space registers beyond the standard 64 bytes which have read side effects, but this is rare. [30]
An option ROM for the PC platform (i.e. the IBM PC and derived successor computer systems) is a piece of firmware that resides in ROM on an expansion card (or stored along with the main system BIOS), which gets executed to initialize the device and (optionally) add support for the device to the BIOS. In its usual use, it is essentially a driver ...
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
ISA PnP or (legacy) Plug & Play ISA was a plug-and-play system that used a combination of modifications to hardware, the system BIOS, and operating system software to automatically manage resource allocations. It was superseded by the PCI bus during the mid-1990s. The PCI plug and play (autoconfiguration) is based on the PCI BIOS Specification ...
A PCI-104 single-board computer. PC/104 (or PC104) is a family of embedded computer standards which define both form factors and computer buses by the PC/104 Consortium.Its name derives from the 104 pins on the interboard connector in the original PC/104 specification [1] [2] and has been retained in subsequent revisions, despite changes to connectors.
PCI Express devices communicate via a logical connection called an interconnect[ 10 ] or link. A link is a point-to-point communication channel between two PCI Express ports allowing both of them to send and receive ordinary PCI requests (configuration, I/O or memory read/write) and interrupts (INTx, MSI or MSI-X).