enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. List of GM bellhousing patterns - Wikipedia

    en.wikipedia.org/wiki/List_of_GM_bellhousing...

    The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

  3. Chevrolet Stovebolt engine - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_Stovebolt_engine

    The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.

  4. Bell housing - Wikipedia

    en.wikipedia.org/wiki/Bell_housing

    The starter motor may mount to it, and it may support clutch and/or shifter linkage. [2] A Bellhousing may be a separate housing bolted to the gearbox, or it may be an integral portion of the transmission housing, particularly with front wheel drive transmissions. An integral bell has a front bolt pattern that matches the engine to which it ...

  5. Starter (engine) - Wikipedia

    en.wikipedia.org/wiki/Starter_(engine)

    An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.

  6. Starter ring gear - Wikipedia

    en.wikipedia.org/wiki/Starter_ring_gear

    Starter ring gear attached to a flywheel. In cars with a manual transmission, the starter ring gear is fitted to the outer diameter of the flywheel.The ring gear is usually fixed to the flywheel through use of an interference fit, [2] which is achieved by heating the ring gear and so that thermal expansion allows it to be placed around the flywheel.

  7. Hydraulic tappet - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_tappet

    Hydraulic lifters were nearly universal on cars designed in the 1980s, but some newer cars have reverted to bucket-and-shim mechanical lifters. Although these do not run as quietly and are not maintenance-free, they are cheaper. [citation needed] Nearly all modern non-hydraulic lifter arrangements are on overhead cam engines. [citation needed]

  8. Starter solenoid - Wikipedia

    en.wikipedia.org/wiki/Starter_solenoid

    A starter solenoid is an electromagnet which is actuated to engage the starter motor of an internal combustion engine. It is normally attached directly to the starter motor which it controls. Its primary function is as the actuating coil of a contactor (a relay designed for large electric currents) which connects the battery to the starter ...

  9. Delco Electronics - Wikipedia

    en.wikipedia.org/wiki/Delco_Electronics

    Delco Electronics Corporation was the automotive electronics design and manufacturing subsidiary of General Motors based in Kokomo, Indiana, that manufactured Delco Automobile radios and other electric products found in GM cars.