enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Residual-current device - Wikipedia

   en.wikipedia.org/wiki/Residual-current_device

   A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device that interrupts an electrical circuit when the current passing through a conductor is not equal and opposite in both directions, therefore indicating leakage current to ground or current flowing to another powered conductor.

3. Double switching - Wikipedia

   en.wikipedia.org/wiki/Double_switching

   On the other hand double switching is inherently less prone to wrong side failures; it helps overcome short-circuit faults that are hard to test for. Partial double switching might double switch the lever controls, and the track circuits between one signal and the next, while single switching the track circuits in the less critical overlap ...

4. Circuit breaker - Wikipedia

   en.wikipedia.org/wiki/Circuit_breaker

   Three single-phase Soviet/Russian 110-kV oil circuit breakers 400 kV SF 6 live-tank circuit breakers Electrical power transmission networks are protected and controlled by high-voltage breakers. The definition of high voltage varies but in power transmission work is usually thought to be 72.5 kV or higher, according to a recent definition by ...

5. Switch - Wikipedia

   en.wikipedia.org/wiki/Switch

   Single pole, single throw: One-way: Two-way: A simple on-off switch: The two terminals are either connected together or disconnected from each other. An example is a light switch. SPST-NO. Form A [4] Single pole, single throw, normally open A simple on-off switch. The two terminals are normally disconnected (open) and are closed when the switch ...

6. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Single-pole circuit breakers feed 120 V circuits from one of the 120 V buses within the panel, or two-pole circuit breakers feed 240-volt circuits from both buses. 120 V circuits are the most common, and used to power NEMA 1 and NEMA 5 outlets, and most residential and light commercial direct-wired lighting circuits.

7. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   These switches appear externally similar to single pole, single throw (SPST) switches, but have extra connections which allow a circuit to be controlled from multiple locations. Toggling the switch disconnects one "traveler" terminal and connects the other. Electrically, a typical "3-way" switch is a single pole, double throw (SPDT) switch. By ...