Search results
Results from the WOW.Com Content Network
The leading-edge droop flap is a device on the leading edge of aircraft wings designed to improve airflow at high angles of attack. The droop flap is similar to the leading-edge slat and the Krueger flap , but with the difference that the entire leading edge section rotates downwards, whereas the slat and Krueger flap are panels which move away ...
Trailing edge flaps extended on the right on a typical airliner (an Airbus A310-300). Leading edge slats are also extended, on the left. A flap is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight. Flaps are usually mounted on the wing trailing edges of a fixed-wing aircraft. Flaps are used to reduce the ...
The triple-slotted trailing edge flaps are well displayed and the Krueger flaps on the leading edge also are visible. In aircraft design and aerospace engineering, a high-lift device is a component or mechanism on an aircraft's wing that increases the amount of lift produced by the wing. The device may be a fixed component, or a movable ...
Krueger flaps deployed from the leading edge of a Boeing 747 (top left and right in photo). Krueger flaps, or Krüger flaps, are lift enhancement devices that may be fitted to the leading edge of an aircraft wing. Unlike slats or droop flaps, the main wing upper surface and its nose is not changed. Instead, a portion of the lower wing is ...
Flaps are mounted on the trailing edge on the inboard section of each wing (near the wing roots). They are deflected down to increase the effective curvature of the wing. Flaps raise the maximum lift coefficient of the aircraft and therefore reduce its stalling speed. [5]
Blown flaps of the Hunting H.126. Blown flaps, blown wing or jet flaps are powered aerodynamic high-lift devices used on the wings of certain aircraft to improve their low-speed flight characteristics. They use air blown through nozzles to shape the airflow over the rear edge of the wing, directing the flow downward to increase the lift ...
Work started by taking an existing F/A-18 airframe modified with a preproduction wing, and added an outboard leading edge flap drive system and an updated flight control computer. Active aeroelastic wing control laws were developed to flex the wing, and flight instrumentation was used to accurately measure the aeroelastic performance of the ...
As wing sweep is conventionally measured at the 25% chord line [3] an unswept wing may have a swept or tapered leading edge. Some aircraft, like the General Dynamics F-111, have swing-wings where the sweep of both wing and leading edge can be varied. In high-speed aircraft, compression heating of the air ahead of the wings can cause extreme ...