Search results
Results from the WOW.Com Content Network
The hydraulic motor is the rotary counterpart of the hydraulic cylinder as a linear actuator. Most broadly, the category of devices called hydraulic motors has sometimes included those that run on hydropower (namely, water engines and water motors) but in today's terminology the name usually refers more specifically to motors that use hydraulic ...
The 8L 90 is the first 8-speed automatic transmission built by General Motors. It was debuting in 2014 and is designed for use in longitudinal engine applications either attached to the front-located engine [3] with a standard bell housing or in the rear of the car adjacent to the differential (as in the Corvette). It is a hydraulic (hydramatic ...
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.
The 4L80-E (and similar 4L85-E) is a series of automatic transmissions from General Motors. Designed for longitudinal engine configurations, the series included 4 forward gears. It was the 4-speed electronically commanded evolution of the 3-speed Turbo-Hydramatic 400, first produced in October 1963. 4L80-Es were optioned only in Chevrolet/GMC ...
The medium-duty 1930 A-series trucks received the all-new 278.7 cu in (4.6 L) FB-3 six-cylinder engine, with overhead valves and seven main bearings. This was complemented by larger versions of the same engine and was built until late 1940 (as the FBB), [ 7 ] the line-up being expanded downward by the smaller FA-series (later FAB) in 1933.
SPMTs are used for transporting massive objects, such as large bridge sections, [1] oil refining equipment, cranes, motors, spacecraft and other objects that are too big or heavy for trucks. Ballast tractors can however provide traction and braking for the SPMTs on inclines and descents.
If a hydraulic rotary pump with the displacement 10 cc/rev is connected to a hydraulic rotary motor with 100 cc/rev, the shaft torque required to drive the pump is one-tenth of the torque then available at the motor shaft, but the shaft speed (rev/min) for the motor is also only one-tenth of the pump shaft speed.
TP POWER TP100XL brushless DC motor [39] 7 kg 15 lb 75 kW 101 hp 9.0 kW/kg 5.5 hp/lb Electric vehicles: Emrax 268 brushless AC motor [40] 19.9 kg 44 lb 230 kW 310 hp 11.56 kW/kg 7.03 hp/lb Electric aircraft: Lucid Motors brushless DC motor [35] 31.4 kg 69 lb 500 kW 670 hp 15.8 kW/kg 9.68 hp/lb Electric vehicle H3X HPDM-250, direct drive [41]