Search results
Results from the WOW.Com Content Network
A multicore cable is a type of electrical cable that combines multiple signals or power feeds into a single jacketed cable. [1] The term is normally only used in relation to a cable that has more cores than commonly encountered. [ 2 ]
Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]
In stage lighting, [1] a multicable (otherwise known as multi-core cable or mult) is a type of heavy-duty electrical cable used in theaters to power lights. The basic construction involves a bundle of individual conductors surrounded by a single outer jacket. Whereas single cables only have three conductors, multicable has ten or more.
The antenna feed system or antenna feed is the cable or conductor, and other associated equipment, which connects the transmitter or receiver with the antenna and makes the two devices compatible. [ 1 ] [ 2 ] In a radio transmitter, the transmitter generates an alternating current of radio frequency , and the feed system feeds the current to ...
The current Cutler Naval Station was built during 1960 and became operational on January 4, 1961. It has a transmission power of 2 megawatts. As with all VLF stations, the transmitter has a very small bandwidth, and so cannot transmit audio (speech) but only coded text messages, at a relatively low data rate.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The ground rods create a ground plane under the antenna which increases the gain. The ground rods may extend horizontally from the base, but in antennas fed by coaxial cable as shown here they are usually sloped downward to increase the radiation resistance of the antenna from the 36 ohms of a quarter wave monopole closer to 50 ohms, so the ...