Ads
related to: do i need a preamp with my receiver
Search results
Results from the WOW.Com Content Network
An example of a typical high-end stereo preamplifier.. A preamplifier, also known as a preamp, is an electronic amplifier that converts a weak electrical signal into an output signal strong enough to be noise-tolerant and strong enough for further processing, or for sending to a power amplifier and a loudspeaker. [1]
Most phonograph cartridges also have a low output level and require a preamp; typically, a home stereo integrated amplifier or receiver will have a special phono input. This input passes the signal through a phono preamp, which applies RIAA equalization to the signal as well as boosting it to line level.
An audio/video receiver (AVR) or a stereo receiver is a consumer electronics component used in a home theater or hi-fi system. Its purpose is to receive audio and video signals from a number of sources, and to process them and provide power amplifiers to drive loudspeakers , and/or route the video to displays such as a television , monitor or ...
Marantz 2050L AM/FM stereo tuner (USA; 1978-1980) [1]. In electronics and radio, a tuner is a type of receiver subsystem that receives RF transmissions, such as AM or FM broadcasts, and converts the selected carrier frequency into a form suitable for further processing or output, such as to an amplifier or loudspeaker.
Circuit of a very simple preselector. For any one frequency, using a larger tuning coil results in a narrower bandwidth, i.e. greater rejection of out-of-tune signals.. A preselector is a name for an electronic device that connects between a radio antenna and a radio receiver.
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...
Some older tape recorders, and equipment like receivers designed to connect to them, use a 5-pin DIN connector to connect left and right for record and playback with a single cable. Adapters between this connector and RCA connectors have used white and red for left and right channel recording, and blue (or sometimes black) and yellow for ...
Quadraphonic sound was a commercial failure when first introduced due to a variety of technical issues and format incompatibilities. Four channel audio formats can be more expensive to produce than standard two-channel stereo. Playback requires additional speakers and amplifier channels. It may also require specially designed decoding equipment.
Ads
related to: do i need a preamp with my receiver