Search results
Results from the WOW.Com Content Network
Three-point hitches are composed of three movable arms. The two lower arms—the hitch lifting arms—are controlled by the hydraulic system, and provide lifting, lowering, and even tilting to the arms. The upper center arm—called the top link—is movable, but is usually not powered by the tractor's hydraulic system.
The 800 series was replaced with the 8000 series by 1978, which offered more powerful engine configurations and an improved hydraulic lift option, yet retained the eight-speed transaxle. Many of the parts for the 800 and 8000 series designs, excepting the engine, are the same or compatible, and are readily available as new and used parts online ...
From 1947 to 1954, International Harvester produced the Farmall Super A, with the same engine displacement, but with a hydraulic lift system. About 94,000 Super A tractors were produced, including Super AV variants. [6]
All 9N tractors were painted dark grey. This tractor has a rear PTO, which could be used to drive three-point or towed implements. The Ferguson hitch was designed to solve some of the problems found in the earlier Fordson tractors, such as flipping over if the plow hit an obstruction. The upper link also would adjust the hydraulic lift to use ...
The R also incorporated live hydraulics. PowrTrol, as it was known, provided the operator the ability to lift equipment by the pull of a lever. A pump powered by the PTO clutch provided 1,800 psi (12 MPa) of hydraulic pressure to a lever controlled valve. At 45 hp (34 kW) at the drawbar and 50 hp (37 kW) at the belt, it was the most fuel ...
Styled by Raymond Loewy, [1] [2] it was one of International Harvester's "letter series", replacing the Farmall F-20.The H was rated for two 14-inch (36 cm) plows. [3]The H is equipped with a 4-cylinder in-line overhead valve with a 152-cubic-inch (2,490-cubic-centimetre) displacement and a 6-volt, positive ground electrical system with generator, (when so ordered or retrofitted).
Semi-tractor/trailers have to stay on relatively flat ground, and are not rated for full off-road use. On improved roads they could tow up to 55,000 lb (25,000 kg) with 25,000 lb (11,000 kg) on their fifth wheel. [7] [14] Tractor trucks normally towed a 12-ton, 2-axle trailer. There were stake and platform, van, low-bed, and tanker bodies.
A hydraulic cantilever tail lift on the back of a truck Four stages of deployment on an ambulance tail lift Control for a tail lift. A tail lift (term used in the UK, also called a "liftgate" in North America) is a mechanical device permanently installed on the rear of a work truck, van, or lorry, and is designed to facilitate the handling of goods from ground level or a loading dock to the ...