enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. GM 10.5-inch 14-bolt differential - Wikipedia

   en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

   While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found ...

3. Differential (mechanical device) - Wikipedia

   en.wikipedia.org/wiki/Differential_(mechanical...

   Spur-gear differential. A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...

4. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

5. List of gear nomenclature - Wikipedia

   en.wikipedia.org/wiki/List_of_gear_nomenclature

   The back cone of a bevel or hypoid gear is an imaginary cone tangent to the outer ends of the teeth, with its elements perpendicular to those of the pitch cone. The surface of the gear blank at the outer ends of the teeth is customarily formed to such a back cone. [1]

6. Dana 70 - Wikipedia

   en.wikipedia.org/wiki/Dana_70

   The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.

7. Dana 60 - Wikipedia

   en.wikipedia.org/wiki/Dana_60

   Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...