Search results
Results from the WOW.Com Content Network
Disengaging the clutch for each shift out of, and then into, each gear is double clutching or declutching. [4] Due to the absence of a neutral spacing, double-clutching is impossible for sequential gear changes, as with a fully sequential gearbox used in motorcycles and racecars. The double-clutching technique involves the following steps:
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
To double-clutch while downshifting: depress the clutch pedal and move the gear lever to neutral, release the clutch pedal, "blip" the throttle to speed up the layshaft to increase the rotational speed of the lower gear, depress the clutch pedal again, move the gear lever to the lower gear, then release the clutch pedal.
Shift time refers to the time interval between gear changes in a transmission. This interval is the time in which power delivery is transferred to the next selected gear, and engine speed is reduced or increased to synchronize the speed of the next gear. Shift time is usually in reference to motor vehicles, but can apply to any gearbox.
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
The Ford unit is a six-speed with one clutch acting on reverse, first, third, and fifth gears, and the other used for second, fourth, sixth gears. As the first gear is engaged, the 2-4-6 clutch is disengaged and the second gear cogs are engaged. At the appropriate time, the R-1-3-5 clutch is disengaged and the 2-4-6 clutch is engaged.
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."