Ads
related to: ata hard drive connector cable replacement
Search results
Results from the WOW.Com Content Network
A data cable (top) and control cable (below) connecting a controller card and an ST-506 type HDD. Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
ATA-2 also was the first to note that devices other than hard drives could be attached to the interface: 3.1.7 Device: Device is a storage peripheral. Traditionally, a device on the ATA interface has been a hard disk drive, but any form of storage device may be placed on the ATA interface provided it adheres to this standard.
A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm). These types are used for many types of equipment, in particular for interconnections within an enclosure. For personal computers, this size was used in floppy-disk-drive cables and older or custom Parallel ATA cables.
SATA Express host-side connector, formally known as the "host plug", accepts both SATA Express and legacy standard SATA data cables. [13] [31]Connectors used for SATA Express were selected specifically to ensure backward compatibility with legacy SATA devices where possible, without the need for additional adapters or converters. [2]
The ST-506 and ST-412 (sometimes written ST506 and ST412 [1]) were early hard disk drive products introduced by Seagate in 1980 and 1981 respectively, [1] that later became construed as hard disk drive interfaces: the ST-506 disk interface and the ST-412 disk interface. Introduced in 1980, the ST-506 was the first 5.25 inch HDD.
Ads
related to: ata hard drive connector cable replacement