enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   Osram's Fluorescent Miniature (FM) tubes; Sylvania Luxline Slim T2 Linear; T4 1 ⁄ 2: 12.7 G5 bi-pin: Slim lamps. Power ratings and lengths not standardized (and not the same) between different manufacturers T5 T16 5 ⁄ 8: 15.9 G5 bi-pin; 2GX13 quad-pin; G10q quad-pin; Original 4–13 W miniature fluorescent range from 1950s or earlier. [1]

3. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   [1] [3] To prevent this, fluorescent tubes are connected to the power line through a ballast. The ballast adds positive impedance (AC resistance) to the circuit to counteract the negative resistance of the tube, limiting the current. [1] Several American magnetic ballasts for fluorescent lamps. The top is a rapid start series autoregulator ...

4. Fluorescent lamp - Wikipedia

   en.wikipedia.org/wiki/Fluorescent_lamp

   A fluorescent lamp, or fluorescent tube, is a low-pressure mercury-vapor gas-discharge lamp that uses fluorescence to produce visible light. An electric current in the gas excites mercury vapor, to produce ultraviolet and make a phosphor coating in the lamp glow.

5. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

6. High-intensity discharge lamp - Wikipedia

   en.wikipedia.org/wiki/High-intensity_discharge_lamp

   Ballasts for discharge lamps. Like fluorescent lamps, HID lamps require a ballast to start and maintain their arcs. The method used to initially strike the arc varies: mercury-vapor lamps and some metal-halide lamps are usually started using a third electrode near one of the main electrodes, while other lamp styles are usually started using ...

7. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...

8. Resonant inverter - Wikipedia

   en.wikipedia.org/wiki/Resonant_inverter

   This type of inverter produces an approximately sinusoidal waveform at a high output frequency, ranging from 20 kHz to 100 MHz, and is commonly used in relatively fixed output applications, for example, induction heating, sonar transmitters, fluorescent lighting, or ultrasonic generators. Due to the high switching frequency, the size of the ...

9. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...