enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   The throughput of each USB port is determined by the slower speed of either the USB port or the USB device connected to the port. High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port.

3. USB communications - Wikipedia

   en.wikipedia.org/wiki/USB_communications

   All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x.

4. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...

5. USB hub - Wikipedia

   en.wikipedia.org/wiki/USB_hub

   To allow high-speed (USB 2.0) devices to operate in their fastest mode, all hubs between the devices and the computer must be high-speed. High-speed devices should fall back to full-speed (USB 1.1) when plugged into a full-speed hub (or connected to an older full-speed computer port). While high-speed hubs can communicate at all device speeds ...

6. InterChip USB - Wikipedia

   en.wikipedia.org/wiki/InterChip_USB

   High-Speed Inter-Chip (HSIC) is a chip-to-chip variant of USB 2.0 that eliminates the conventional analog transceivers found in normal USB. It was adopted as a standard by the USB-IF in 2007. The HSIC physical layer uses about 50% less power and 75% less board area compared to traditional USB 2.0. HSIC uses two signals at 1.2 V and has a ...

7. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   1.2/0.075 kbit/s: 0.12/0.0075 kB/s ... Parallel (Centronics/IEEE 1284) ECP (Extended Capability Port) 20 Mbit/s: 2.5 ... USB 2.0 high speed: 480 Mbit/s: 60 ...