Search results
Results from the WOW.Com Content Network
Some dirt bikes use this system, which is sometimes referred to as an auto-clutch transmission. [31] [29] [32] These include the Honda CRF110F [108] [109] and Yamaha TT-R110E. [6] [110] [111] The conventional motorcycle foot shifter is retained, but the manual hand-clutch lever is no longer required.
Above a certain engine speed - when the bike is properly in motion, so the gearbox input shaft is also rotating quickly and so allowing the engine to accelerate further by way of clutch slip - the outward pressure of the weighted friction plates is sufficient that the clutch will enter full lock-up, the same as a conventional plate-clutch with ...
Old-style tank shift. Regular clutch hand Shifter - This is where the shifter is a regular knob either located on the tank, which operates through a linkage to the transmission (tank shifter) or on a lever bolted directly to the top of the transmission (jockey shifter or slap shifter depending on the transmission design) and involves the semi-complex task of foot clutch operation and hand ...
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
If the driving member rotates in the direction that would unwind the spring expands minutely and slips although with some drag. Because of this, spring clutches must typically be lubricated with light oil. Rotating the driving member the other way makes the spring wrap itself tightly around the driving surface and the clutch locks up very quickly.
The clutch pedal controls the pressure plate (clutch engaged – the clutch pedal is not being pressed) or not connected to the engine (clutch disengaged – the clutch pedal is being pressed down). When the engine is running and the clutch is engaged (i.e., clutch pedal up), the flywheel spins the clutch pressure plate and hence the transmission.
This type of clutch is designed to partially disengage or "slip" when the rear wheel tries to drive the engine faster than it would run under its own power. The engine braking forces in conventional clutches will normally be transmitted back along the drive chain causing the rear wheel to hop, chatter or lose traction. [ 3 ]