enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. File:Durham tube diagram.jpg - Wikipedia

   en.wikipedia.org/wiki/File:Durham_tube_diagram.jpg

   Durham_tube_diagram.jpg (158 × 592 pixels, file size: 26 KB, MIME type: image/jpeg) This is a file from the Wikimedia Commons . Information from its description page there is shown below.

3. File:PRINCE2 Process Model Diagram.pdf - Wikipedia

   en.wikipedia.org/wiki/File:PRINCE2_Process_Model...

   Original file (1,754 × 1,239 pixels, file size: 25 KB, MIME type: application/pdf) This is a file from the Wikimedia Commons . Information from its description page there is shown below.

4. Plumbing drawing - Wikipedia

   en.wikipedia.org/wiki/Plumbing_drawing

   Every pipes should me marked with pipe sizes. If the drawing is detailed, fixture units also should be marked along with the pipe. [1] [2] In the realm of shop drawings, additional clarity is achieved by incorporating sections that reveal the intersection points of various pipes. These sections serve as visual guides, ensuring that the ...

5. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

6. Hydraulic diameter - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_diameter

   For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, and a is the water depth, then D H = 4a. For a fully filled duct or pipe whose cross-section is a convex regular polygon , the hydraulic diameter is equivalent to the diameter D {\displaystyle D} of a circle inscribed within the wetted perimeter .

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [ 15 ] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size.