Search results
Results from the WOW.Com Content Network
Its SI unit is the reciprocal seconds (s −1); other common units of measurement include the hertz (Hz), cycles per second (cps), and revolutions per minute (rpm). [1] [a] [b] Rotational frequency can be obtained dividing angular frequency, ω, by a full turn (2π radians): ν=ω/(2π rad).
The SI unit of frequency is the hertz (Hz), [4] named after the German physicist Heinrich Hertz by the International Electrotechnical Commission in 1930. It was adopted by the CGPM (Conférence générale des poids et mesures) in 1960, officially replacing the previous name, cycle per second (cps).
The cycle per second is a once-common English name for the unit of frequency now known as the hertz (Hz). Cycles per second may be denoted by c.p.s., c/s, or, ambiguously, just "cycles" (Cyc., Cy., C, or c). The term comes from repetitive phenomena such as sound waves having a frequency measurable as a number of oscillations, or cycles, per ...
The hertz is defined as one per second for periodic events. The International Committee for Weights and Measures defined the second as "the duration of 9 192 631 770 periods of the radiation corresponding to the transition between the two hyperfine levels of the ground state of the caesium-133 atom" [3] [4] and then adds: "It follows that the hyperfine splitting in the ground state of the ...
The carrier frequency is 1800 Hz, meaning that the lower cut off frequency is 1,800 − 1,200/2 = 1,200 Hz, and the upper cutoff frequency is 1,800 + 1,200/2 = 2,400 Hz. A V.34 modem may transmit symbols at a baud rate of 3,420 Bd, and each symbol can carry up to ten bits, resulting in a gross bit rate of 3420 × 10 = 34,200 bit/s.
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
It is measured in hertz (pulses per second). Clock rate or clock speed in computing typically refers to the frequency at which the clock generator of a processor can generate pulses used to synchronize the operations of its components. [1] It is used as an indicator of the processor's speed. Clock rate is measured in the SI unit of frequency ...
One nonillionth of a second. rontosecond: 10 −27 s: One octillionth of a second. yoctosecond: 10 −24 s: One septillionth of a second. jiffy (physics) 3 × 10 −24 s: The amount of time light takes to travel one fermi (about the size of a nucleon) in a vacuum. zeptosecond: 10 −21 s: One sextillionth of a second.