enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Board foot - Wikipedia

    en.wikipedia.org/wiki/Board_foot

    The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada.It equals the volume of a board that is one foot (30.5 cm) in length, one foot (30.5 cm) in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters.

  3. Lumber - Wikipedia

    en.wikipedia.org/wiki/Lumber

    As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...

  4. Parallel-strand lumber - Wikipedia

    en.wikipedia.org/wiki/Parallel-strand_lumber

    The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...

  5. Cross-laminated timber - Wikipedia

    en.wikipedia.org/wiki/Cross-laminated_timber

    Cross-laminated timber (CLT) is a subcategory of engineered wood [1] panel product made from gluing together at least three layers [2] of solid-sawn lumber (i.e. lumber cut from a single log). [3] Each layer of boards is usually oriented perpendicular to adjacent layers and glued on the wide faces of each board, usually in a symmetric way so ...

  6. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Typical dimensions of today's "two by four" is 1.5 by 3.5 inches (38 mm × 89 mm) dimensional lumber prior to sanding and are typically placed 16 inches (406 mm) from each other's center, but sometimes also at 12 inches (305 mm) or 24 inches (610 mm).

  7. Flat sawing - Wikipedia

    en.wikipedia.org/wiki/Flat_sawing

    Lumber produced by flat sawing from a log. Plank A has been cut from the middle, and is as wide as the original log. Plank B has been cut closer to the side, and shows slash grain. Flat sawing, flitch sawing or plain sawing is a woodworking process that produces flat-cut or plain-cut boards of lumber. [1]

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Pulpwood - Wikipedia

    en.wikipedia.org/wiki/Pulpwood

    The use of solid hardwoods has decreased during the last couple centuries, most likely due to the development of wood-based materials that allow for larger constructions not limited to the size of trees. [4] Trees of any size can be used for pulpwood, but trees that are 5-9 inches in diameter at breast height are normally used.