Search results
Results from the WOW.Com Content Network
A piston is a component of reciprocating engines. It is located in a cylinder and is made gas-tight by piston rings. Its purpose is to transfer force from expanding gas in the cylinder to the crankshaft via a piston rod and/or connecting rod. In two-stroke engines the piston also acts as a valve by covering and uncovering ports in the cylinder ...
Free-piston engine used as a gas generator to drive a turbine. A free-piston engine is a linear, 'crankless' internal combustion engine, in which the piston motion is not controlled by a crankshaft but determined by the interaction of forces from the combustion chamber gases, a rebound device (e.g., a piston in a closed cylinder) and a load device (e.g. a gas compressor or a linear alternator).
The connecting rod is attached to the piston by a swivelling gudgeon pin (US: wrist pin). This pin is mounted within the piston: unlike the steam engine, there is no piston rod or crosshead (except big two stroke engines). The typical piston design is on the picture. This type of piston is widely used in car diesel engines. According to purpose ...
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
The average cost of a used car is $26,510, according to Kelley Blue Book. While this is significantly less than what you can expect to pay for a new vehicle, it's still not exactly cheap. And with ...
And as further noted, as car loan interest rates are now averaging well over 6%, this can mean significant long-term costs. In turn Consumer Reports compiled a list of cheap cars — starting at ...
It was composed of metal cylinder sleeves, metal combustion chamber tops, metal piston crowns, bearings, valves and seats, and a stock 2.3L Pinto crankshaft. Nearly everything else in the engine, including the block, rods and piston skirts, were made of glass reinforced Polyamide-imide thermoplastic resins manufactured at the time by Amoco ...