Search results
Results from the WOW.Com Content Network
These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [i] held against a matching conical seat by a spring. As these valves must work at high pressure ...
Injection pump for a 12-cylinder diesel engine. An injection pump is the device that pumps fuel into the cylinders of a diesel engine.Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt) that also drives the camshaft.
For the next several seconds, the injector pulse width is wider than normal to provide sufficient fuel for starting. Idle control is performed by adjusting a stepper-motor-driven bypass valve in the intake plenum. When the ignition is switched off, the ECU winds the bypass valve fully open to provide enough air the next time the engine is started.
A blowout preventer (BOP) (pronounced B-O-P) [1] is a specialized valve or similar mechanical device, used to seal, control and monitor oil and gas wells to prevent blowouts, the uncontrolled release of crude oil or natural gas from a well. They are usually installed in stacks of other valves.
A Digifant II DF-1 Engine Control Unit used in '91 Volkswagen Golf Cabriolet with 2E engine. Digifant is an Engine Management System operated by an Engine Control Unit that actuates outputs, such as fuel injection and ignition systems, using information derived from sensor inputs, such as engine speed, exhaust oxygen and intake air flow. [1]
The pump plunger begins descending, but the spill valve is open, and fuel recirculates back to the return line. Injection phase Partway through the pump stroke, the solenoid is energized, which closes the spill valve. The fuel is forced into the cylinder through the spray tip. Pressure reduction phase Toward the end of the pump stroke, the ...
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
The pump element is on the way down, and as long as the solenoid valve remains de-energized the fuel line is open and fuel flows in into the return duct. Injection phase The pump element is still on the way down, the solenoid is now energised and the fuel line is immediately closed. The fuel cannot pass back into the return duct, and is now ...