Search results
Results from the WOW.Com Content Network
In the early years, steam engines and electric motors were tried, but with limited success. In the 20th century, the internal combustion engine (ICE), became dominant. In 2015, the internal combustion engine remains the most widely used but a resurgence of electricity seems likely because of increasing concern about ic engine exhaust gas emissions.
The ignition system of an internal combustion engines depends on the type of engine and the fuel used. Petrol engines are typically ignited by a precisely timed spark, and diesel engines by compression heating. Historically, outside flame and hot-tube systems were used, see hot bulb engine.
Typical airflow in a four-stroke engine: In stroke #1, the pistons suck in (aspirate) air to the combustion chamber through the opened inlet valve.. A naturally aspirated engine, also known as a normally aspirated engine, and abbreviated to N/A or NA, is an internal combustion engine in which air intake depends solely on atmospheric pressure and does not have forced induction through a ...
Due to higher voltage, more energy can be recuperated when decelerating or going downhill. Electric motor can start the engine with vehicle in gear making take-off with stalled combustion engine smooth and instantaneous. [10] 48V starter-generator can also be mounted differently and be uncoupled from combustion engine by transmission or clutch.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Help; Learn to edit; Community portal; Recent changes; Upload file
The Modular Engine Management System, or MEMS, is an electronic control system used on engines in passenger cars built by Rover Group in the 1990s. As its name implies, it was adaptable for a variety of engine management demands, including electronically controlled carburetion as well as single- and multi-point fuel injection (both with and without electronic ignition control).
Oil circulation system Gerotor type oil pump from a scooter engine. The oil pump is an internal combustion engine part that circulates engine oil under pressure to the rotating bearings, the sliding pistons and the camshaft of the engine. This lubricates the bearings, allows the use of higher-capacity fluid bearings, and also assists in cooling ...
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...