enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Caliber (artillery) - Wikipedia

    en.wikipedia.org/wiki/Caliber_(artillery)

    For naval rifles, the initial change was to actual bore, thus facilitating the manufacture of standard projectiles. They then began to measure the effective length (and therefore range) of the weapon in calibers. These are a measure of the standardized length of the barrel versus the rifled bore of the barrel.

  3. Gun chronograph - Wikipedia

    en.wikipedia.org/wiki/Gun_chronograph

    A ballistic chronograph or gun chronograph is a measuring instrument used to measure the velocity of a projectile in flight, typically fired from a gun or other firearm. The instrument is often useful for tasks such as gauging the utility of a firearm or safety of non-lethal projectiles fired from items such as a paintball gun or BB gun .

  4. Accurizing - Wikipedia

    en.wikipedia.org/wiki/Accurizing

    Comparison of milliradian (mil) and minute of arc (moa).. Since adjusting the point of impact to match the point of aim is relatively simple with any type of adjustable sights, the primary goal of accurizing is to increase the precision of the firearm, which is generally measured by looking at the dispersion of a number of shots fired at the same point of aim.

  5. Ballistics by the Inch - Wikipedia

    en.wikipedia.org/wiki/Ballistics_by_the_Inch

    Each brand of ammunition in each caliber/cartridge was tested at 18". Then, the barrel was removed and 1" was cut off the end of the barrel and the cut end was dressed. Once all the cartridges had been tested at 18" and the barrels were cut and ready, each brand was tested again at 17" and so on, right down to a 2" barrel.

  6. Freebore - Wikipedia

    en.wikipedia.org/wiki/Freebore

    Chamber illustration indicating the various sections of a typical rifle chamber. The freebore is the cyan colored section just ahead of the neck. In firearms, freebore (also free-bore, free bore, or throat) is the portion of the gun barrel between the chamber and the rifled section of the barrel bore. The freebore is located just forward of the ...

  7. Gun dynamics - Wikipedia

    en.wikipedia.org/wiki/Gun_dynamics

    Gun B has poor consistency, but good accuracy. [citation needed] Figure 3: The mean points of impact for guns A and B (case 2) A more realistic possibility is shown in Figure 3. In this case, assuming that each series had the same consistency as those shown in Figure 1, gun A shows good consistency and accuracy, and gun B is poor on both counts.

  8. Shot grouping - Wikipedia

    en.wikipedia.org/wiki/Shot_grouping

    [1] [2] On the other hand, the grouping displacement (the distance between the calculated group center and the intended point of aim) is a measure of accuracy. Tightness of shot groupings are calculated by measuring the maximum distance between any two bullet holes on the target (center-to-center) in length measurements such as millimeters or ...

  9. Internal ballistics - Wikipedia

    en.wikipedia.org/wiki/Internal_ballistics

    Since barrel length is limited by practical concerns to about arm's length for a rifle and much shorter for a handgun, increasing bore diameter is the normal way to increase the efficiency of a cartridge. The limit to bore diameter is generally the sectional density of the projectile (see external ballistics).