enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [29] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.

3. Tire load sensitivity - Wikipedia

   en.wikipedia.org/wiki/Tire_load_sensitivity

   Tire load sensitivity. Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. . The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increas

4. Slip ratio - Wikipedia

   en.wikipedia.org/wiki/Slip_ratio

   Slip ratio is a means of calculating and expressing the slipping behavior of the wheel of an automobile.It is of fundamental importance in the field of vehicle dynamics, as it allows to understand the relationship between the deformation of the tire and the longitudinal forces (i.e. the forces responsible for forward acceleration and braking) acting upon it.

5. Low rolling resistance tire - Wikipedia

   en.wikipedia.org/wiki/Low_rolling_resistance_tire

   Low rolling resistance tires are designed to reduce the energy loss as a tire rolls, decreasing the required rolling effort — and in the case of automotive applications, improving vehicle fuel efficiency as approximately 5–15% of the fuel consumed by a typical gas car may be used to overcome rolling resistance.

6. SAE J2452 - Wikipedia

   en.wikipedia.org/wiki/SAE_J2452

   SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...

7. Radial tire - Wikipedia

   en.wikipedia.org/wiki/Radial_tire

   The low crown angle gave rigidity to support the tread and the high sidewall angle gave comfort. To increase strength, the manufacturer would increase the number of plies, and the heat buildup in the tire. [20] By comparison, radial tires lay all of the cord plies at 90 degrees to the direction of travel (that is, across the tire from lip to lip).