enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST connectors are electrical connectors manufactured to the design standards originally developed by J.S.T. Mfg. Co. (Japan Solderless Terminal). [1] JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors.

3. Board-to-board connector - Wikipedia

   en.wikipedia.org/wiki/Board-to-board_connector

   Board-to-board (BTB) connectors are used to connect printed circuit boards (PCB), electronic components that contain a conductive pattern printed on the surface of the insulating base in an accurate and repeatable manner. Each terminal on a BTB connector is connected to a PCB. A BTB connector includes housing and a specific number of terminals.

4. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are commonly color-coded to indicate the connector size and, hence, their capacity. They are commonly used as an alternative to terminal blocks or soldering of conductors, since they are quicker to install and, unlike soldered or crimped connections, allow easy subsequent removal for future modifications.

5. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

6. UHF connector - Wikipedia

   en.wikipedia.org/wiki/UHF_connector

   The UHF connector [4] is a name for a fairly common, but old type of threaded RF connector. [5] [6] The connector design was invented in the 1930s for use in the radio industry. [7] [4] It is a widely used standard connector for HF transmission lines on full-sized radio equipment, with BNC connectors predominating for smaller, hand-held ...

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Modern IDC technology developed after and was influenced by research on wire-wrap and crimp connector technology originally pioneered by Western Electric, Bell Telephone Labs, and others. [3] Although originally designed to connect only solid (single-stranded) conductors, IDC technology was eventually extended to multiple- stranded wire as well.

8. Welded wire mesh - Wikipedia

   en.wikipedia.org/wiki/Welded_wire_mesh

   This type of mesh is a square grid of uniformly placed wires, welded at all intersections, and meeting the requirements of ASTM A185 and A497 or other standards. [1] The sizes are specified by combining the spacing, in inches or mm, and the wire cross section area in hundredths of square inches or mm2.

9. IEC metric screw sized connectors - Wikipedia

   en.wikipedia.org/wiki/IEC_metric_screw_sized...

   IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.