enow.com Web Search

  1. Ads

    related to: commercial toilets with wall flushometers and heat pull down valve assembly

Search results

  1. Results from the WOW.Com Content Network
  2. Flushometer - Wikipedia

    en.wikipedia.org/wiki/Flushometer

    The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down. A groove in this cylinder allows water from the main supply to flow through when it is in a mid position. The valve is shut off at both its top and bottom positions.

  3. Sloan Valve Company - Wikipedia

    en.wikipedia.org/wiki/Sloan_Valve_Company

    The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907.

  4. Flush toilet - Wikipedia

    en.wikipedia.org/wiki/Flush_toilet

    A flush toilet (also known as a flushing toilet, water closet (WC); see also toilet names) is a toilet that disposes of human waste (i.e., urine and feces) by collecting it in a bowl and then using the force of water to channel it ("flush" it) through a drainpipe to another location for treatment, either nearby or at a communal facility.

  5. Reduced pressure zone device - Wikipedia

    en.wikipedia.org/wiki/Reduced_pressure_zone_device

    There is a variety of manufacturers of these gauges, but most utilize either a three-valve or a five-valve design to test the RPZD in different ways. In the UK , [ 6 ] Illinois, New York , [ 7 ] Texas , [ 8 ] and Missouri ( RsMO 10c60-11 ), the RPZD valve must be tested at least every 12 months by an accredited tester.

  6. Dual flush toilet - Wikipedia

    en.wikipedia.org/wiki/Dual_flush_toilet

    A dual flush toilet; note the two buttons at the top of the cistern. A dual flush toilet is a variation of the flush toilet that uses two buttons or a handle mechanism to flush different amounts of water. The purpose of this mechanism is to reduce the volume of water used to flush different types of waste.

  7. Ballcock - Wikipedia

    en.wikipedia.org/wiki/Ballcock

    When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.

  1. Ads

    related to: commercial toilets with wall flushometers and heat pull down valve assembly