Search results
Results from the WOW.Com Content Network
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.
A high-shear mixer uses a rotating impeller or high-speed rotor, or a series of such impellers or inline rotors, usually powered by an electric motor, to "work" the fluid, creating flow and shear. The tip velocity, or speed of the fluid at the outside diameter of the rotor, will be higher than the velocity at the center of the rotor, and it is ...
Acrylic paint glazes are often used to create more depth in an image. When glaze medium is applied to acrylic paint, the paint becomes more transparent and will reveal the layer of paint used beneath it, which modifies the color. [5] This technique is commonly used to create more realistic images.
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...
As liquid exits the impeller it has high kinetic energy and the volute directs this flow through to the discharge. As the fluid travels along the volute it is joined by more and more fluid exiting the impeller but, as the cross sectional area of the volute increases, the velocity is maintained if the pump is running close to the design point.
The liquid then separates from the vanes causing mechanical problems due to cavitation, vibration and performance problems due to turbulence and poor filling of the impeller. This results in premature seal, bearing and impeller failure, high maintenance costs, high power consumption, and less-than-specified head and/or flow.
At the same time, a circulation occurs, resulting in an inward aimed force, that has a forward component. The duct therefore has a positive thrust. This is normally larger than the thrust reduction of the propeller. The small clearance between the propeller and duct reduces tip vortex, increasing efficiency.
Atalanta was built for Jay Gould the same year that American Yacht Club was founded and its inclusion in the club's fleet of steamships was considered a great coup. [2] ...