Search results
Results from the WOW.Com Content Network
In terms of usage, hot rolling processes more tonnage than any other manufacturing process, and cold rolling processes the most tonnage out of all cold working processes. [ 1 ] [ 2 ] Roll stands holding pairs of rolls are grouped together into rolling mills that can quickly process metal, typically steel , into products such as structural steel ...
Mill scale on an anvil. Mill scale, often shortened to just scale, is the flaky surface of hot rolled steel, consisting of the mixed iron oxides iron(II) oxide (FeO, wüstite), iron(III) oxide (Fe 2 O 3, hematite), and iron(II,III) oxide (Fe 3 O 4, magnetite).
Diagram of bar drawing; the workpiece is pulled from left (tension) rather than pushed from the right (compression). Drawing is a manufacturing process that uses tensile forces to elongate metal, glass, or plastic. As the material is drawn (pulled), it stretches and becomes thinner, achieving a desired shape and thickness.
After being directly fed into a hot rolling mill, the as-cast strip is typically rolled down to 1–3 mm thickness strip. Copper bar casting: As-cast dimensions range from 35–75 mm thick, and from 50-150 mm wide. After being directly fed into a hot rolling mill, the as-cast bar is typically rolled into 8 mm diameter rod to be used for wire ...
Up to 3 tons of (then expensive) coke was burnt for each ton of steel produced. When rolled into bars such steel was sold at £50 to £60 (approximately £3,390 to £4,070 in 2008) [11] a long ton. The most difficult and laborious part of the process was the production of wrought iron in finery forges in Sweden.
Cross-sections of continuously rolled structural shapes, showing the change induced by each rolling mill. Structural shape rolling, also known as shape rolling and profile rolling, [1] is the rolling and roll forming of structural shapes by passing them through a rolling mill to bend or deform the workpiece to a desired shape while maintaining a constant cross-section.
Roll forming is, among the manufacturing processes, one of the simplest. It typically begins with a large coil of sheet metal, between 1 inch (2.5 cm) and 20 inches (51 cm) in width, and 0.004 inches (0.10 mm) and 0.125 inches (3.2 mm) thick, supported on an uncoiler.
DFM guidelines define a set of rules for a person designing a product to ease the manufacturing process, reduce cost and time. For example, if a hole is to be drilled , if the designer specifies a standard hole size then it reduces the cost because the drill bits of unusual sizes are not readily available they have to be custom made.