Ads
related to: one pipe vs two steam turbine generator specifications- Limited-Time Savings
Buy Overstock Tools & Supplies At
Deep Discounts While Supplies Last.
- Chemicals
Search Our Offerings By Chemical
Name Or CAS Number.
- Shop by Industry
Browse Our Product Catalog
By Industry or Workflow.
- Laboratory Equipment
Leading Supplier Of Laboratory
Equipment & Analytical Instruments.
- Limited-Time Savings
Search results
Results from the WOW.Com Content Network
In commercial power plants, there are two to four steam generators per reactor; each steam generator can measure up to 70 feet (21 m) in height and weigh as much as 800 tons. Each steam generator can contain anywhere from 3,000 to 16,000 tubes, each about .75 inches (19 mm) in diameter.
In the energy-rich Persian Gulf region, the steam from the HRSG is used for desalination plants. [1] Universities are ideal candidates for HRSG applications. They can use a gas turbine to produce high-reliability electricity for campus use. The HRSG can recover the heat from the gas turbine to produce steam/hot water for district heating or ...
This system used two large steam turbine generators to drive an electric motor on each of four shafts. The system was less costly initially than reduction gears and made the ships more maneuverable in port, with the shafts able to reverse rapidly and deliver more reverse power than with most geared systems.
There is usually a high-pressure turbine at one end, followed by an intermediate-pressure turbine, and finally one, two, or three low-pressure turbines, and the shaft that connects to the generator. As steam moves through the system and loses pressure and thermal energy, it expands in volume, requiring increasing diameter and longer blades at ...
The basic configuration was described as a 2-on-1 design, meaning that two gas turbines produced steam to feed one steam turbine. Supplemental firing was utilized to increase steam production so as to fill the 100 MW single-case steam turbine. In the initial design, approximately 20% of the fuel input was fired in the duct burner.
Turbo generators are used for high shaft rotational speeds, typical of steam and gas turbines. The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a ...
A typical single-shaft system has one gas turbine, one steam turbine, one generator and one heat recovery steam generator (HRSG). The gas turbine and steam turbine are both coupled in tandem to a single electrical generator on a single shaft. This arrangement is simpler to operate, smaller, with a lower startup cost.
Herreshoff steam generator in a Peruvian torpedo boat of 1879. A monotube steam generator is a type of steam generator consisting of a single tube, usually in a multi-layer spiral, that forms a once-through steam generator (OTSG). The first of these was the Herreshoff steam generator of 1873. [1]
Ads
related to: one pipe vs two steam turbine generator specifications