enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rain gutter - Wikipedia

   en.wikipedia.org/wiki/Rain_gutter

   A 4-metre gutter, enduring a −5 °C to 25 °C temperature range will need space to expand, 30 × 4 × 0.06 = 7.2 mm within its end stops. [28] As a rule of thumb a 4-inch (100 mm) gutter with a single 68-millimetre (2.7 in) downpipe will drain a 600-square-foot (56 m 2 ) roof.

3. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

5. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Roman roofs used lead in conduits and drain pipes [14] and some were also covered with lead. Lead was also used for piping and for making baths. [15] Plumbing reached its early apex in ancient Rome, which saw the introduction of expansive systems of aqueducts, tile wastewater removal, and widespread use of lead pipes.

6. Downspout - Wikipedia

   en.wikipedia.org/wiki/Downspout

   This may be a simple bend of, typically around 70 degrees, at the bottom. Alternatively a downspout may lead to a sewer, a runoff water drain or a seepway to allow the water to soak into the ground through seepage. Decorative heads are sometimes added, these being low-height gargoyles.

7. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.