Search results
Results from the WOW.Com Content Network
The limiting oxygen concentration (LOC), [1] also known as the minimum oxygen concentration (MOC), [2] is defined as the limiting concentration of oxygen below which combustion is not possible, independent of the concentration of fuel. It is expressed in units of volume percent of oxygen.
It is also called n-octanol-water partition ratio. [2] [3] [4] K ow serves as a measure of the relationship between lipophilicity (fat solubility) and hydrophilicity (water solubility) of a substance. The value is greater than one if a substance is more soluble in fat-like solvents such as n-octanol, and less than one if it is more soluble in ...
It is first determined whether M is indeed greater than 1.0 by calculating M from the subsonic equation. If M is greater than 1.0 at that point, then the value of M from the subsonic equation is used as the initial condition for fixed point iteration of the supersonic equation, which usually converges very rapidly. [8]
The values for the octanol-water system in the following table are from the Dortmund Data Bank. [ 15 ] [ better source needed ] They are sorted by the partition coefficient, smallest to largest (acetamide being hydrophilic, and 2,2',4,4',5-pentachlorobiphenyl lipophilic), and are presented with the temperature at which they were measured (which ...
Help; Learn to edit; Community portal; Recent changes; Upload file; Special pages
The resulting body of polluted water within an aquifer is called a plume, with its migrating edges called plume fronts. Plumes are used to locate, map, and measure water pollution within the aquifer's total body of water, and plume fronts to determine directions and speed of the contamination's spreading in it.
A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%). B Calculated values *Derived data by calculation.
PNEC values are intended to be conservative and predict the concentration at which a chemical will likely have no toxic effect. They are not intended to predict the upper limit of concentration of a chemical that has a toxic effect. [1] [2] [3] PNEC values are often used in environmental risk assessment as a tool in ecotoxicology.