Search results
Results from the WOW.Com Content Network
The Mach 2 F-104 Starfighter used numerous slender spars to allow for a wing of unusually thin section; the F-16 Fighting Falcon uses a similar construction. Other aircraft like the F-4 Phantom, F-15 Eagle and others use 3 or more spars to give sufficient strength in a relatively thin wing, and thus qualify as multi-spar aircraft. [10]
The Excalibur was designed as "clone" [1] of the Quad City Challenger II aircraft. The company took the basic Challenger design and incorporated many changes, including mounting the engine upright allowing larger propellers and the Rotax gearbox to be mounted, lengthening the tailboom and enlarging the tail vertical surface to increase stability, shortening the ailerons and replacing control ...
The Mite is constructed mainly of fabric-covered wood, with a single spruce and plywood "D" wing spar. The wing aft of the spar is fabric-covered. [2] The airfoil selected for the design was the NACA 64A215. [3] The M-18 represented the first time a NACA 6-series airfoil had been used on a civil aircraft after World War II. [1] The aircraft ...
Challenger I (Challenger UL) Single seat, 31.5 ft (9.6 m) wingspan gives lower stall speed. Can be fitted with a variety of engines. Qualifies as a US "Experimental - Amateur-Built", Light sport aircraft or with the 22 hp (16 kW) Hirth F-33 engine as a US FAR 103 Ultralight Vehicle, 800 reported completed and flown by the fall of 2011.
The wing uses a Clark Y-cross-section airfoil; spars and ribs are spruce. [6] [3] [7] The steel-tube parallel wings struts simplified internal wing structure, and enabled the wings to fold back for over-the-road towing. [3] The fuselage is of fabric-covered tubular construction, and wing struts are steel tube. There is a door in the right side.
The SA26 Merlin is a pressurized Excalibur fitted with a different Lycoming TIGO-540 6-cylinder geared piston engine. The TIGO 540 was used despite the fact that one of the reasons the IO-720 was used in the Excalibur was that the Queen Air series' IGSO-480 and IGSO-540 engines from the same manufacturer were so troublesome.
The Avid Flyer is a conventional layout, single engine, side by side two seat light aircraft, with a strut-braced high wing configuration. Aluminum tubes serve as leading edge/main spar and rear spar, each wing being supported by a pair of tubular lift struts. Sawn plywood wing ribs are bonded to the aluminum tube spars using a filled epoxy ...
Data from Sport Aviation, Plane & Pilot and Purdy General characteristics Crew: one Capacity: one passenger in tandem seating Length: 22 ft 5 in (6.83 m) Wingspan: 35 ft 3 in (10.74 m) Height: 6 ft 8 in (2.03 m) Wing area: 178.5 sq ft (16.58 m 2) Airfoil: USA 35B Empty weight: 695 lb (315 kg) Gross weight: 1,400 lb (635 kg) Fuel capacity: 12 US Gallons, 45.42 litres Powerplant: 1 × Lycoming O ...