Search results
Results from the WOW.Com Content Network
The frequency band initially allocated was 2500–2690 MHz (the "2.6 GHz band") consisting of 22–23 analogue 8 MHz channels; digital TV was restricted to 2524–2668 MHz, consisting of 18 digital 8 MHz channels. Two digital TV standards were used: DVB-T/MPEG-2 in the old Chorus franchise area and DVB-C/MPEG-2 in the old NTL franchise area ...
For example, to downconvert the incoming signals from Astra 1KR, which transmits in a frequency block of 10.70–11.70 GHz, to within a standard European receiver's IF tuning range of 950–2,150 MHz, a 9.75 GHz local oscillator frequency is used, producing a block of signals in the band 950–1,950 MHz.
A number of satellite dishes. Satellite television is a service that delivers television programming to viewers by relaying it from a communications satellite orbiting the Earth directly to the viewer's location. [1] The signals are received via an outdoor parabolic antenna commonly referred to as a satellite dish and a low-noise block ...
North American frequency assignments differ from those used in Europe and other countries. Typically, the lower half of the Ku band contains communications satellites and free-to-air or ethnic-language programming, using linearly-polarised LNBs; the upper half of the Ku band contains circular-polarised direct broadcast satellite signals.
FM channel 200, 87.9 MHz, overlaps TV 6. This is used only by K200AA.; TV 6 analog audio can be heard on FM 87.75 on most broadcast radio receivers as well as on a European TV tuned to channel E4A or channel IC, but at lower volume than wideband FM broadcast stations, because of the lower deviation.
An advantage of parabolic antennas is that most of the structure of the antenna (all of it except the feed antenna) is nonresonant, so it can function over a wide range of frequencies (i.e. a wide bandwidth). [3] All that is necessary to change the frequency of operation is to replace the feed antenna with one that operates at the desired ...
In addition, the satellite also gets a DC to low frequency band to power the dish's block converter and select the dish antenna polarization (e.g., voltage signaling or DiSEqC). The diplexer is useful in homes that are already wired with one cable, because it eliminates the need to install a second cable.
In an optical fibre system at the LNB the four sub-bands are "stacked" in frequency, one above the other, at 0.95 GHz-3.0 GHz (the whole frequency range received in vertical polarisation) and 3.4 GHz-5.45 GHz (horizontal polarisation) and transmitted together as a modulated optical signal down the fibre cable using a 1310 nm semiconductor laser.