Ads
related to: latch 4in w hasp screw and bolt lock 1 1/2 tapebay.com has been visited by 1M+ users in the past month
boltdepot.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
A latch bolt is an extremely common latch type, typically part of a lockset. It is a spring-loaded bolt with an angled edge. [1] [2] When the door is pushed closed, the angled edge of the latch bolt engages with the lip of the strike plate; a spring allows the bolt to retract. Once the door is fully closed, the bolt automatically extends into ...
A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer
The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...
Metal fire-resistance rated door with a lockset consisting of a locking latch bolt operated by lever handle with an escutcheon that encompasses the locking mechanism.. A lockset (alternatively lock set) is the hardware and components that make up the locking or latching mechanism that can usually be found on a door or other hinged object but can also include sliding doors and dividers. [1]
The Chubb detector lock is a variation of the lever lock which was designed to detect and prevent picking attempts. Lever locks can be drilled, but usually a template or stencil is required to mark the drilling point, as the lock mechanism is commonly mortised into the door and so it is harder to determine the point at which to drill.
A good tap drill is 85% (± 2 pp) of major diameter for coarse threads, and 90% (± 2 pp) of major diameter for fine threads. [ 1 ] For metric V threads , the concept of major minus pitch (i.e., the major or widest diameter of the intended screw in millimeters minus the pitch of the threads of that screw in millimeters per thread) yields a good ...
Ads
related to: latch 4in w hasp screw and bolt lock 1 1/2 tapebay.com has been visited by 1M+ users in the past month
boltdepot.com has been visited by 10K+ users in the past month