Search results
Results from the WOW.Com Content Network
The pressure at which sound becomes painful for a listener is the pain threshold pressure for that person at that time. The threshold pressure for sound varies with frequency and can be age-dependent. People who have been exposed to more noise/music usually have a higher threshold pressure. [3] Threshold shift can also cause threshold pressure ...
Such a difference can exceed 100 dB which represents a factor of 100,000 in amplitude and a factor 10,000,000,000 in power. [4] [5] The dynamic range of human hearing is roughly 140 dB, [6] [7] varying with frequency, [8] from the threshold of hearing (around −9 dB SPL [8] [9] [10] at 3 kHz) to the threshold of pain (from 120 to 140 dB SPL ...
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
The OSNR is the ratio between the signal power and the noise power in a given bandwidth. Most commonly a reference bandwidth of 0.1 nm is used. This bandwidth is independent of the modulation format, the frequency and the receiver. For instance an OSNR of 20 dB/0.1 nm could be given, even the signal of 40 GBit DPSK would not fit in this bandwidth.
A compressor reduces the level of an audio signal if its amplitude exceeds a certain threshold. Threshold is commonly set in decibels (dBFS for digital compressors and dBu for hardware compressors), [8] where a lower threshold (e.g. −60 dB) means a larger portion of the signal is treated. When the signal level is below the threshold, no ...
A tone at the frequency of 4000 Hz is presented for 60 seconds at an intensity of 5 decibels above the patient's absolute threshold of hearing. If the patient stops hearing the tone before 60 seconds, the intensity level is increased by another 5 decibels with the procedure repeated until the tone can be heard for the full 60 seconds or until no decibel level can be found where the tone can be ...
Pain tolerance is the maximum level of pain that a person is able to tolerate. Pain tolerance is distinct from pain threshold (the point at which pain begins to be felt). [1] The perception of pain that goes in to pain tolerance has two major components. First is the biological component—the headache or skin prickling that activates pain ...
24-bit and 32-bit audio does not require dithering, as the noise level of the digital converter is always louder than the required level of any dither that might be applied. 24-bit audio could theoretically encode 144 dB of dynamic range, and 32-bit audio can achieve 192 dB, but this is almost impossible to achieve in the real world, as even ...