enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. HDMI - Wikipedia

   en.wikipedia.org/wiki/HDMI

   Previous HDMI versions use three data channels (each operating at up to 6.0 Gbit/s in HDMI 2.0, or up to 3.4 Gbit/s in HDMI 1.4), with an additional channel for the TMDS clock signal, which runs at a fraction of the data channel speed (one tenth the speed, or up to 340 MHz, for signaling rates up to 3.4 Gbit/s; one fortieth the speed, or up to ...

3. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   1 Mini-DIN 4-pin, 1 Mini-DIN 7-pin, 1 Mini-VGA, 2 BNC, 2 RCA connectors, 8-pin DIN, [4] SCART 21-pin: S-VHS, some laptop computers, analog broadcast video, 1980-1990s home computers including the Commodore 64, C128 and Atari 8-bit computers: The 4-pin mini-DIN that is most common in consumer products today debuted in JVC's 1987 S-VHS. The 7-pin ...

4. Cycloidal drive - Wikipedia

   en.wikipedia.org/wiki/Cycloidal_drive

   Many modern precision drives provide the eccentric motion through multiple shafts that also transmit the output force, typically 2 to 5 shafts arranged in the same circular pattern as the output rollers of the most basic design. The shafts are driven through planetary-like gears by a central input shaft.

5. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   A drive shaft system weighs more than a chain system, usually 0.5–1 kg (1–2 lb) heavier. Many of the advantages claimed by drive shaft's proponents can be achieved on a chain-driven bicycle, such as covering the chain and sprockets. Use of lightweight derailleur gears with a high number of ratios is impossible, although hub gears can be used.

6. Differential (mechanical device) - Wikipedia

   en.wikipedia.org/wiki/Differential_(mechanical...

   The functions of this design are to change the axis of rotation by 90 degrees (from the propshaft to the half-shafts) and provide a reduction in the gear ratio. The components of the ring-and-pinion differential shown in the schematic diagram on the right are: 1. Output shafts 2. Drive gear 3. Output gears 4. Planetary gears 5. Carrier 6.

7. Constant-velocity joint - Wikipedia

   en.wikipedia.org/wiki/Constant-velocity_joint

   A control yoke is added to keep the input and output shafts aligned. The control yoke uses a spherical pantograph scissor mechanism to bisect the angle between the input and output shafts and to maintain the joints at a relative phase angle of zero. The alignment ensures constant angular velocity at all joint angles.