Search results
Results from the WOW.Com Content Network
Electrical breakdown in an electric discharge showing the ribbon-like plasma filaments from a Tesla coil.. In electronics, electrical breakdown or dielectric breakdown is a process that occurs when an electrically insulating material (a dielectric), subjected to a high enough voltage, suddenly becomes a conductor and current flows through it.
A useful macroscopic model that combines an electric field with DLA was developed by Niemeyer, Pietronero, and Weismann in 1984, and is known as the dielectric breakdown model (DBM). [7] Although the electrical breakdown mechanisms of air and PMMA plastic are considerably different, the branching discharges turn out to be related.
In electrical engineering, partial discharge (PD) is a localized dielectric breakdown (DB) (which does not completely bridge the space between the two conductors) of a small portion of a solid or fluid electrical insulation (EI) system under high voltage (HV) stress.
Dielectric breakdown model (DBM) is a macroscopic mathematical model combining the diffusion-limited aggregation model with electric field. It was developed by Niemeyer, Pietronero, and Weismann in 1984. [ 1 ]
Dielectric films tend to exhibit greater dielectric strength than thicker samples of the same material. For instance, the dielectric strength of silicon dioxide films of thickness around 1 μm is about 0.5 GV/m. [3] However very thin layers (below, say, 100 nm) become partially conductive because of electron tunneling.
It represents a local region where the air (or other fluid) has undergone electrical breakdown and become conductive, allowing charge to continuously leak off the conductor into the air. A corona discharge occurs at locations where the strength of the electric field (potential gradient) around a conductor exceeds the dielectric strength of
The ESR is a derived quantity representing the loss due to both the dielectric's conduction electrons and the bound dipole relaxation phenomena mentioned above. In a dielectric, one of the conduction electrons or the dipole relaxation typically dominates loss in a particular dielectric and manufacturing method. For the case of the conduction ...
where is the vacuum permittivity, is the dielectric constant of the polymer and is the thickness of the elastomer film in the current state (during deformation). Usually, strains of DEA are in the order of 10–35%, maximum values reach 300% (the acrylic elastomer VHB 4910, commercially available from 3M, which also supports a high elastic energy density and a high electrical breakdown strength.)