Search results
Results from the WOW.Com Content Network
Examples include a 3-dimensional scale model of a building or the scale drawings of the elevations or plans of a building. [1] In such cases the scale is dimensionless and exact throughout the model or drawing. The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale.
The drawing was made 130 years after the bridge was built. A linear scale, also called a bar scale, scale bar, graphic scale, or graphical scale, is a means of visually showing the scale of a map, nautical chart, engineering drawing, or architectural drawing. A scale bar is common element of map layouts.
Plans are usually "scale drawings", meaning that the plans are drawn at specific ratio relative to the actual size of the place or object. Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ...
A graphical or bar scale. A map would also usually give its scale numerically ("1:50,000", for instance, means that one cm on the map represents 50,000cm of real space, which is 500 meters) A bar scale with the nominal scale expressed as "1:600 000", meaning 1 cm on the map corresponds to 600,000 cm=6 km on the ground.
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
Technical drawing, drafting or drawing, is the act and discipline of composing drawings that visually communicate how something functions or is constructed. Technical drawing is essential for communicating ideas in industry and engineering .
Oblique projection is a simple type of technical drawing of graphical projection used for producing two-dimensional (2D) images of three-dimensional (3D) objects. The objects are not in perspective and so do not correspond to any view of an object that can be obtained in practice, but the technique yields somewhat convincing and useful results.
For example, in Finland the series used is 1.8 mm, 2.5 mm, 3.5 mm, 5.0 mm and 7.0 mm. Except for the very biggest ones, the templates are only suitable for technical pen drawing. For drawing circles and circle-arcs, circle templates which contain a set of suitably-sized holes are used.