Search results
Results from the WOW.Com Content Network
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
True 3G systems such as EV-DO, W-CDMA (including HSPA and HSPA+) provide combined circuit switched and packet switched data and voice services from the outset, usually at far better data rates than 2G networks with their extensions. All of these services can be used to provide combined mobile voice access and Internet access at remote locations.
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
This is a list of countries by Internet connection speed for average and median data transfer rates for Internet access by end-users. The difference between average and median speeds is the way individual measurements are aggregated.
When there is only one user in the network, if necessary it can still use the whole 20-MHz bandwidth by operating at 242-tone RU to reach higher data rate. A 52-Tone RU consists of 48 data subcarriers and 4 pilot subcarriers. 106-tone RU consists of 102 data subcarriers and 4 pilot subcarriers, while A 242-tone RU consists of 234 data ...
Bandwidth commonly measured in bits/second is the maximum rate that information can be transferred Throughput is the actual rate that information is transferred Latency the delay between the sender and the receiver decoding it, this is mainly a function of the signals travel time, and processing time at any nodes the information traverses
802.11g is the third modulation standard for wireless LANs.It works in the 2.4 GHz band (like 802.11b) but operates at a maximum raw data rate of 54 Mbit/s.Using the CSMA/CA transmission scheme, 31.4 Mbit/s [9] is the maximum net throughput possible for packets of 1500 bytes in size and a 54 Mbit/s wireless rate (identical to 802.11a core, except for some additional legacy overhead for ...
IEEE 802.15.4 protocol stack. Devices are designed to interact with each other over a conceptually simple wireless network.The definition of the network layers is based on the OSI model; although only the lower layers are defined in the standard, interaction with upper layers is intended, possibly using an IEEE 802.2 logical link control sublayer accessing the MAC through a convergence sublayer.