Search results
Results from the WOW.Com Content Network
In the case of a water softener, the cation exchange resin is exchanging sodium (the Na + ion of NaCl) for hardness minerals such as calcium and magnesium. A dealkalizer contains strong base anion exchange resin that exchanges chloride (the Cl – ion of the NaCl) for carbonate (CO − 3), bicarbonate (H C O − 3) and sulfate (SO 2− 4). As ...
A study found the mean concentration of sodium in softened water to be 278 mg/L. [24] In 2 liters of water—the amount of drinking water typically suggested for an average adult, this constitutes about 22% of the recommended sodium intake by the US CDC and may make a difference to those who need to significantly limit their sodium consumption.
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
For example, the freezing point of water is 0 °C and 32 °F, and a 5 °C change is the same as a 9 °F change. Thus, to convert from units of Fahrenheit to units of Celsius, one subtracts 32 °F (the offset from the point of reference), divides by 9 °F and multiplies by 5 °C (scales by the ratio of units), and adds 0 °C (the offset from the ...
3 in solution represents 1 molar equivalent, while 1 mole of CO 2− 3 is 2 molar equivalents because twice as many H + ions would be necessary to balance the charge. The total charge of a solution always equals zero. [8] This leads to a parallel definition of alkalinity that is based upon the charge balance of ions in a solution.
The grain per gallon (gpg) is a unit of water hardness defined as 1 grain (64.8 milligrams) of calcium carbonate dissolved in 1 US gallon of water (3.785412 L). It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). Also called Clark degree (in terms of an imperial gallon).
In many cases, the district municipalities are the water services authorities. However, the national government can assign responsibility for service provision to local municipalities. Overall, there are 169 water services authorities in South Africa, including water boards, district municipalities, local municipalities and municipal companies.