Search results
Results from the WOW.Com Content Network
(2) Shared FRS and GMRS simplex; GMRS repeater output. (3) GMRS repeater input. The output frequency of this repeater input is the input frequency minus 5 MHz. (4) FRS transmissions are limited to bandwidth of 11 kHz with a transmitter deviation of +/- 2.5 kHz. Channels are on 12.5 kHz centers. (5) GMRS transmissions may have a bandwidth of 16 ...
While radios designed for the Taiwan market have FRS/GMRS frequencies as part of their channel plan, it is still technically illegal to use equipment designed for the Taiwan market in the United States. FRS, 14 channels, 12.5 kHz spacing: 467.5125 MHz; 467.5250 MHz; 467.5375 MHz; 467.5500 MHz – US GMRS Repeater Ch 15/23 Input
The duplexer is a device which prevents the repeater's high-power transmitter (on the output frequency) from drowning out the users' signal on the repeater receiver (on the input frequency). A diplexer allows two transmitters on different frequencies to use one antenna, and is common in installations where one repeater on 2 m and a second on ...
As of 2016, only low-power (2 W ERP), half duplex GMRS operation is permitted, but a license is not required. [6] Repeater and high-power operations are not permitted. This allows the use of dual-mode FRS/GMRS walkie-talkies, but precludes the use of higher-powered GMRS devices designed for vehicle and base-station purposes..
In same-band repeaters, isolation between transmitter and receiver can be created by using a single antenna and a device called a duplexer. The device is a tuned filter connected to the antenna. In this example, consider a type of device called a band-pass duplexer. It allows, or passes, a band, (or a narrow range,) of frequencies.
These satellites can be used free of charge by licensed amateur radio operators for voice (FM, SSB) and data (AX.25, packet radio, APRS) communications. Currently, over 18 fully operational amateur radio satellites are in orbit. [2] They may be designed to act as repeaters, as linear transponders, and as store and forward digital relays.
Sometimes a transmission range of over 100 kilometres (60 miles) can be achieved through the use of a repeater. Repeaters are on channels 1–8 and 41–48 and the duplex button should be pressed to access the repeater. [5] All repeaters can be used by anyone, except for channel 5 repeaters, which are for emergencies only.
It can have a repeater input frequency of 467.675 MHz, and a tone squelch of 141.3 Hz. After FCC deregulation of simplex FRS/GMRS radios, FRS users may transmit up to 2 watts on the GMRS emergency channel 20 (462.675 MHz) with 141.3 Hz CTCSS, or channel 20-22. MURS: 151.940 MHz (only available in the United States)