Search results
Results from the WOW.Com Content Network
The water can be used in chilled-water coils to provide air conditioning for buildings. It is estimated that a pipe 1 foot (0.30 m) in diameter can deliver 4,700 gallons of water per minute. Water at 43 °F (6 °C) could provide more than enough air conditioning for a large building.
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
Hybrid Sankey diagram of 2011 U.S. interconnected water and energy flows. The water-energy nexus is the relationship between the water used for energy production, [1] including both electricity and sources of fuel such as oil and natural gas, and the energy consumed to extract, purify, deliver, heat/cool, treat and dispose of water (and wastewater) sometimes referred to as the energy intensity ...
Harvesting that heat energy using a thermoelectric generator can increase the fuel efficiency of the car. Thermoelectric generators have been investigated to replace the alternators in cars demonstrating a 3.45% reduction in fuel consumption. [33] Projections for future improvements are up to a 10% increase in mileage for hybrid vehicles. [34]
If the water returns to a local water body (rather than a circulating cooling tower), it is often tempered with cool 'raw' water to prevent thermal shock when discharged into that body of water. Another form of condensing system is the air-cooled condenser. The process is similar to that of a radiator and fan. Exhaust heat from the low-pressure ...
The efficiency of a thermoelectric device for electricity generation is given by , defined as =.. The maximum efficiency of a thermoelectric device is typically described in terms of its device figure of merit where the maximum device efficiency is approximately given by [7] = + ¯ + ¯ +, where is the fixed temperature at the hot junction, is the fixed temperature at the surface being cooled ...
A working fluid, typically water or steam, is used to transfer the heat into and out of the system. Thermal conductivity of miscibility gap alloys is often higher (up to 400 W/(m⋅K)) than competing technologies [ 37 ] which means quicker "charge" and "discharge" of the thermal storage is possible.
The heated water can then be used in homes. The advantage of solar thermal is that the heated water can be stored until it is needed, eliminating the need for a separate energy storage system. [2] Solar thermal power can also be converted to electricity by using the steam generated from the heated water to drive a turbine connected to a ...