Search results
Results from the WOW.Com Content Network
A rain sensor or rain switch is a switching device activated by rainfall. There are two main applications for rain sensors. There are two main applications for rain sensors. The first is a water conservation device connected to an automatic irrigation system that causes the system to shut down in the event of rainfall.
To refine detection in the event of ambiguity, these devices use the dew point temperature (or, if missing, environmental temperature) and the icing detector output. Thus, if the detector identifies the falling speed for the dual snow/drizzle at an ambient dew point greater than 1 °C (34 °F) it will classify it as drizzle, and below −1 °C ...
The tuning of the system is usually done during commissioning of the detection devices. Microphonic systems are relatively inexpensive compared to other systems and easy to install, but older systems may have a high rate of false alarms caused by wind and other distances. Some newer systems use DSP to process the signal and reduce false alarms.
Weather radar in Norman, Oklahoma with rainshaft Weather (WF44) radar dish University of Oklahoma OU-PRIME C-band, polarimetric, weather radar during construction. Weather radar, also called weather surveillance radar (WSR) and Doppler weather radar, is a type of radar used to locate precipitation, calculate its motion, and estimate its type (rain, snow, hail etc.).
Different types of light sensors. A sensor is a device that produces an output signal for the purpose of detecting a physical phenomenon.. In the broadest definition, a sensor is a device, module, machine, or subsystem that detects events or changes in its environment and sends the information to other electronics, frequently a computer processor.
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
configuration of domestic rainwater harvesting system in Uganda. [1]Rainwater harvesting (RWH) is the collection and storage of rain, rather than allowing it to run off.. Rainwater is collected from a roof-like surface and redirected to a tank, cistern, deep pit (well, shaft, or borehole), aquifer, or a reservoir with percolation, so that it seeps down and restores the ground w
However, in most fielded systems, unwanted clutter and interference sources mean that the noise level changes both spatially and temporally. In this case, a changing threshold can be used, where the threshold level is raised and lowered to maintain a constant probability of false alarm. This is known as constant false alarm rate (CFAR) detection.